Your cart is empty.
Your cart is empty.Product Description
What do you need
- A new strap
- Wrenchs and sockets at the right dimension
- A box cutter
- A wire brush
- A rag
- WD40 or other lubricant
1-Buy the right strap
It may not have been obvious to you, but not all straps are the same. There are several widths (usually 2’’ and 3’’), lengths (depending on the length of the trailer) and especially load capacities. Be sure to choose a model that offers a maximum breaking load at least 20% greater than the weight of your boat, it is insurance for your safety.
Regarding the length, do not take one that’s too short, obviously, but also not too long, because the strap will not fit in the groove provided for this purpose.
2-Remove the old strap
Just unroll the old strap all the way, being careful not to get your fingers caught.
3-Loosen the central bolt
The strap is held in place by a central bolt. It may be the bolt acting axis or another slightly offset. Loosen the nuts of the bolt with two keys. It is possible that the nuts will resist a little because of the corrosion. In this case, use a product like WD 40.
4 -Remove the central bolt and inspect it
Once the bolt is unscrewed, remove it from the winch and remove the strap. If the strap is too old, you may need to cut it with a box cutter at the shaft to remove it. Inspect its shape. It must not be twisted or attacked by corrosion. If it looks bad, it’s better to change it.
5-Do some cleaning
Once the bolt is removed, clean the winch cage and make sure there is no corrosion. If the galvanized coating is a little damaged, you can spray some cold galvanizing. Perform the same operation for the center bolt.
6-Install the hook
Most straps are sold with a new hook. If this is not the case, do not forget to insert the hook into the loop of the strap. Be sure to follow common sense by keeping the strap flat.
7-Install the new strap
Insert the bolt into the winch cage and at the same time slide the bolt into the loop sewn at the end of the strap. Tighten the nuts of the central bolt without tightening too hard, because the the axis needs to remain mobile.
8-Wind the new strap
Wrap the new strap onto the winch drum using the crank. Make sure the strap winds neatly, staying flat and without wrinkling.
9-Hang the strap on the boat
Before you finish winding the strap, do not forget to hang the hook onto the boat’s ring. Wind it until it is tight and make sure that the winch locking pawl is working properly.
10-Finish by lightly greasing the winch
While you’re there, spray a little lubricant on the mechanical part of the winch, it will be easier to handle.
11-Pay attention to the load
Finally, there is normally a place on your winch where your workload capacity is indicated. If necessary, you can refer to the manufacturer’s instructions. Finally, do not replace a cable with a strap, the winch is not designed for this change.
Courtney
July 18, 2025
Perfect fit for my 17ft boat. Strap had broke got a new one the next day. Easy to install. Great price. Also had the clip on end of strap to lock it on to boat. Looks strong
jean kaufmann
May 20, 2025
Needed a strap to pull a blowup dingy onto a trailer. This works great and is more than strong enough.
Taner Dubie
May 18, 2025
It was super easy to install, looks nice and clean with the black, and works great.It's very sturdy and long enough for any circumstance.I would recommend.
Ken
May 12, 2025
Strap was as perfect for my boat.
Maverick
May 6, 2025
works well and very easy to install. The first one we ordered was too long so always check what length you need.
Jack McDonald
May 2, 2025
Bought this for my Shorelander boat trail and it looks like a well constructed, sturdy replacement. Unfortunately I was not able to install it due to the way it attaches to the wench drum. You have to remove the wench drum to access the bolt that feed through the loop on the attachment end. I could not get the main bold out to remove the drum so its still sitting on my bench until I can figure out how to get the dang bolt out. Might want to check how you old one attaches and you can get to the needed interface.!
hollie
April 18, 2025
Easy to install and great quality. Oh, great price as well!
Happy in Idaho
February 28, 2025
My last strap broke as I was in the middle of loading my boat. I was able to tie the ends together in order to get the boat in position. This went on nice an works good.
Marlene MacIntosh
February 12, 2025
In a boat
hautcoeur
February 6, 2025
Ça belle étaient fait ce que je voulais en faire pour mon bateau de pêche..très satisfait
Michael Robinson
January 19, 2025
Very easy to install with a loop on each end and one end with a spring lock hook. If it was any easier, it would install itself. ;)
brad
January 5, 2025
good product at a good price
Tina M B
November 1, 2024
Met our needs - a good purchase
Recommended Products