Your cart is empty.
Your cart is empty.David B
July 27, 2025
These clamps are similar to the Fuel Injection Hose Clamps used on the older VWs.Fit the braided 8mm FI hoses fine.Screw works smoothly to tighten the clamp.Will NOT work on my 6AN 3/8 inch CPE Fuel Hose since the outer diameter is too large.
Andy
May 17, 2025
Cinches up nice and tight -- unlike another brand of similar design that failed to tighten adequately around an 11mm fiberglass post. This also feels more durable than the wormy types -- and looks better too. Seven dollars for a ten-pack seems perfectly fair.
Richard T.
February 13, 2025
Will fit the thicker, 3/8 Evil Energy fuel hose available right here on Amazon. Snugs up very nicely. Preferable to worm drive or spring hose clamps. Well machined and stainless too.
Adran
November 27, 2024
I have a bigger set of these fuel injection hose clamps, but I noticed after a while that I'd almost exclusively used this 14-16mm size and had run out. Most of my applications as it turns out are 3/8" fuel and transmission cooler hose, and this size fits perfectly. These are as good as any other fuel injection hose clamps I have used. Quality is acceptable. Not a complicated device, so it's hard to mess these up. These tend to wear better from repeated use than regular worm gear hose clamps, and they are supposed to apply pressure more evenly around the hose in order to increase reliability of the seal. They also do not have the annoying serrations that tend to dig into rubber. I always use this style clamp now, if possible.
Wesley
November 18, 2024
I like this style clamp, and needed the SS for use on the boat. This design has proven to be better over long run with salt water exposure. Re-hosing the entire tank to carb fuel system and used several of these clamps.I'd go up a size for my thicker fuel line - be sure to get an accurate OD.
R. Allen
October 11, 2024
I used a few yesterday where the cheap spring clamps just were not getting a good seal. These clamps stopped the leak.
Recommended Products