Shopping Cart

Your cart is empty.

Your cart is empty.

Super Heavy Duty 5/8' Keyless Drill Chuck with MT2 Shank for Woodlathe and Pillar drills

4.7 (7) Write Review
Free shipping on orders over $29.99

$27.45

$ 11 .99 $11.99

In Stock

1.Model:K16+mt2


About this item

  • Heavy Duty Keyless Drill Chuck includes the 5/8"(16mm) drill chuck,B16 Taper and B16 to #2 MT Adapter
  • Keyless chuck for quick changes of bits.
  • The drill chuck can be installed on the headstock or tailstock of a woodturning lathe and pillar drills that accepts MT2 accessories.
  • Knurled grips and exceptional accuracy make this chuck an indispensable part of any shop.
  • Holds drill bits, pen mandrel shafts, small turnings, dowels and workpieces up to 5/8 inch in diameter.


Product Description

bonder
木旋夹头

Drill Chuck Used on the Woodturning Lathe

BMWOOD Super Heavy Duty 5/8" Drill Chuck with MT2 Shank and Chuck Key for Wood lathe and drill press

Heavy Duty Drill Chuck includes the 5/8"(16mm) drill chuck, #2 Morse Taper Arbor and Jaw Tightening Key.

The drill chuck can be installed on the headstock or tailstock of a lathe that accepts #2MT accessories.

Easily open and close the three chuck jaws using the included chuck key.

Holds drill bits, pen mandrel shafts, small turnings, dowels and workpieces up to 5/8 inch in diameter.

Installs easily with the simple tap of a rubber mallet.

KL16D+MT2

BMWOOD Super Heavy Duty 5/8" Keyless Drill Chuck with MT2 Shank for Wood lathe and drill press

This precision milled, Large Keyless Chuck with a large diameter knurled body provides plenty of hand torque for tightening.

Quick open and close the three chuck jaws by hand.

The drill chuck can be installed on the headstock or tailstock of a lathe that accepts #2MT accessories.

Holds drill bits, pen mandrel shafts, small turnings, dowels and workpieces up to 5/8 inch in diameter.

tu 3

Marshall S.
July 4, 2025
Nice machine work on all parts. Jaws close smoothly and completely with no slippage. So nice and quick when changing bits without needing a chuck key.
Happy Camper
June 16, 2025
Used on wood lathe , drilled 1 1/4" drill bit into hard wood and did not let bit turn in the trail stock. Great holding
Mare
February 8, 2025
My husband is a wood turner. He loved it!!!
SavvyBuyer
January 1, 2025
The media could not be loaded.
Sotto voce
December 13, 2024
As advertised. Works great on the drill press.
maxx
November 21, 2024
It worked pretty well for a while, but the machining is not great. I suppose if I worked in a Chinese factory, having to crank out tons of these chucks in a day, I might not be so big on this... But they straight up didn't machine it on the lathe correctly. Like the runout on the outer body is bad enough to where the knurling on one side is 1mm higher than the other side.
Mark R Hicks
October 24, 2024