Your cart is empty.
Your cart is empty.Product Description
Outboard Motor Support
Cendasun transom savers for outboard motor are compatible with Mercury outboards 135 hp–300 hp. Yamaha (plus new SHO) outboards 115 hp–350 hp. Honda outboards 90 hp–300 hp. Evinrude outboards 150 hp–300 hp (if you drill the hole in the wedge bigger), except Generation 2. Johnson four-stroke outboards 150 hp–300 hp, V6 4-stroke. Suzuki four-stroke outboards DF140 to DF350 hp
Get Wedge Transom Saver Motor Toter Support to make your outdoor life, cookout life, beach life better!
Why Do You Need a Outboard Trailer Support
- Our boat motor transom support is made of EPDM rubber
- and high-tech plastic which simply fits over the outboard’s trim/tilt piston.
- 1 × Boat Motor Support
Customer
July 9, 2025
Perfect use on my 2006 Yamaha 225 only used on one cylinder, no problems
Ralph S.
June 23, 2025
Perfect fit and relieves bounce and load on upper motor. 250 hp suzuki
LJL
May 29, 2025
Great easy to install product! Having owned boats my entire life and several transom savers (including the old wood block) this product is small, easy to use and store. Best part, it does the job.
Customer
April 21, 2025
The hole in the rubber that goes over the lifting piston was not big enough for my piston top. I had to drill the rubber to facilitate a proper fit. The transom saver is a good quality product, easy to use and performs well.
oiltrash
April 12, 2025
Fits my 2023 Suzuki 200.
Joe Graybill
April 3, 2025
Didn’t fit my motor
Richard Michalski
December 31, 2024
It fits all 150-200- 225-250 motors
TomFromMn
December 10, 2024
Honestly, save the $30 and put it towards better alternatives.
Peter
November 26, 2024
Bought for a 115hp yamaha. It fits and works, but it bends more than I thought it should when the engine is lowered onto it. Still supports the motor and if I tilt the motor up a bit it appears fine.
Mario
November 18, 2024
L'article est conforme à mes attentes et il est arrivé plutôt que prévu! Merci!
Recommended Products
$18.99
$ 7 .99 $7.99