Your cart is empty.
Your cart is empty.A full set of hardware for mounting Burton Re:Flex bindings to either The Channel, 3D, or 4x4 snowboarding mounting patterns. Includes eight silver M6x16 screws and washers for 3D and 4x4 mounts as well as four black M6x13 screws and washers for The Channel mounting system. Don't screw with random collections; use the correct hardware to ensure a proper mount.
Hidalgo
July 30, 2025
Exactly what I needed to make my repair.
Orange
July 23, 2025
Burton authenticated
LeRoy D
July 6, 2025
Exactly what I was expecting. Perfect to replace
Mehmet
June 10, 2025
It is shorter than advertised. That’s why I knocked off one stock otherwise good product. It is gripping the board with only two full turns. It is likely enough, but it doesn’t give me confidence
Timothy Frasier
April 25, 2025
I picked up some 2005 Burton bindings at a garage sale, but the screws were missing. Got these figuring they would fit since they’re Burton, but they are way too short for the binding plates that came with my bindings. Dunno what to do now except send them back. These are 16mm and I’m thinking I might need 18 or 20 mm? Picture shows it in without the washer. With the washer it doesn’t even clear the plate hole.
RM Jeeps
March 24, 2025
These worked great in my older Burton board.Would buy again if I needed them.
Anthony
February 25, 2025
Exactly what I needed
Alexandre
February 22, 2025
Great original product, very nice
Guillaume Laplante
January 25, 2025
Use to replace lost fasteners on my snowboards. Direct fit good quality. Exactly as described. Recommend.
Marcus
November 27, 2024
This product fit perfectly to replace the old hardware for my binding and board.
Recommended Products
