Your cart is empty.
Your cart is empty.
Specifications:
- Frequency Range: 0.1-1300MHz
- HF/VHF/UHF continuous coverage
- In/Out Impedance: 50 ohms
- Measurement Parameters: SWR, R, +Jx, -Jx, Z, Returnloss
- Measurement Mode: Single point measurement, Scanning (Frequency Sweep), and TDR Mode
- SWR Measurement Range: 1.0-1999（Single Point Mode), 1.0-20.0 (Scan Mode)
- Display Modes: Numerical display, curve display, simith chart
- Connector Type: UHF N-type connector
- VNA: SMA
- SMA OPEN-SHORT-LOAD Calibration Kit x 1
- LCD size: 480x272 4.3" TFT LCD display
- Touch Screen Type: Capacitive
- All capacitive touchscreen on the display – no buttons are needed
- Power Source: USB or Internal Power Supply
- Built-in charging circuitry and DC-DC booster
- Maximum charging current: 5V/1.5A
- External Storage Method: TF card
- Dimensions: 135*85*30 mm (Not including the size of prominent ports)
John H. Bradford
June 30, 2025
Have been using this for almost a year now and it works great. Edges of the case are a little sharp, so watch that. Operationally, it's great!
George Cullen
October 16, 2024
The product use and value is described very well in thorough YouTube videos. So, I won’t duplicate that here. My review is limited to the red on/off button. I ordered one on Amazon for $186-. Never got to use it. First try was to calibrate it. On/off button got stuck in the on position. It would not release. Was stuck at and below the case. Opened the case to learn this critical button is attached 90 degrees @ PCB, only by the solder point. There is nothing to counter the down force applied to the button, except a tiny solder point. -SO- sent it back. UPS paid by Amazon. Two days later, rplcmnt arrived. Photo is rplcmt unit. Note wonky angle of button. Bound to fail. For $186, they can do far better. Use only gentle pressure for on/off.-
Recommended Products
$9,779.00
$ 99 .00 $99.00
$217.11
$ 99 .00 $99.00