Your cart is empty.
Your cart is empty.Product Description
GHmarine Power Trim Sender Limit Switch Kit fits MerCruiser Stern Drive MC-I R MR Alpha Alpha Gen II and Bravo drives
Fits Following MerCruiser Stern Drives:
- MC-I
- R
- MR
- Alpha one
- Alpha One Gen 2
- Bravo I II III
Replaces:
- Mercruiser 17693A2, 63115A12, 805320A03, 805320A1, 88678A4, 88678A5, 96863A15
- Sierra 18-7633
- Red Rhino MR-971
Package Include:
- 1x Trim Sender and Limit Kit
- 1x Tape
- 2x Line
TinyTim
July 1, 2025
These worked out great
John C. Tapocik
June 2, 2025
As good if not better than the factory replacement
David
April 15, 2025
Worked but the half's had to be sealed since they were not molded correctly
Beth Anderson
March 31, 2025
I was disappointed that there were no instructions. Specifically, there is a gear alignment mark that needs to be checked prior to installation and you need to know the distance the ram drive should stop when raising the drive. Although you can figure it out, it would be handy to know which way to rotate the switch to make the drive move higher/lower. The trim stop switch worked fine, but the trim sender was too sensitive (I checked before installing it). I was expecting the trim gauge to gradual sweep up/down, but barely turning the sender gear caused the gauge to go immediately full up or down. My old sender allows the gauge to move gradually, but does not represent the correct location. Perhaps the sender would work better if I bought a new gauge. It is worth testing the systems prior to installing.
stratulat florentin
March 8, 2025
ok
Caroline
October 12, 2024
We ended up having to buy the part from the boat place
Recommended Products